DESCRIPTION |
XP-10150-BS1-US |
Tsunami® XP 10150 Base Station, 866 Mbps, MIMO 2x2, 22 dBi panel antenna with 11n AP | Part Number : 901-00282 |
XP-10150-BS1-WD |
Tsunami® XP 10150 Base Station, 866 Mbps, MIMO 2x2, 22 dBi panel antenna with 11n AP | Part Number : 901-00284 |
XP-10100-SUA-US |
Tsunami® XP 10100 Subscriber Unit, 866 Mbps, MIMO 2x2, Type-N Connectors with 11n AP | Part Number : 901-00236 |
XP-10100-SUA-WD |
Tsunami® XP 10100 Subscriber Unit, 866 Mbps, MIMO 2x2, Type-N Connectors with 11n AP | Part Number : 901-00237 |
XP-10150-SUR-US |
Tsunami® XP 10150 Subscriber Unit, 866 Mbps, MIMO 2x2, 22 dBi panel antenna with 11n AP | Part Number : 901-00283 |
XP-10150-SUR-WD |
Tsunami® XP 10150 Subscriber Unit, 866 Mbps, MIMO 2x2, 22 dBi panel antenna with 11n AP | Part Number : 901-00285 |
INTERFACES |
WIRED ETHERNET |
Two auto MDI-X RJ45 10/100/1000Mbps Ethernet (Port #1 with PoE in & Data, Port #2 with PoE out & Data) |
WIRELESS PROTOCOL |
- Radio #1: WORP® (Wireless Outdoor Router Protocol), - Radio #2: Wi-Fi (802.11b/g/n) |
RADIO |
|
|
Radio #1 |
Radio #2 |
FREQUENCY |
4.900 – 5.925 GHz (Subject to Country Regulations) |
2.400 – 2.484 (Subject to Country Regulations) |
|
|
802.11n |
802.11g |
802.11b |
MIMO |
2x2:2 |
2x2:2 |
N/A |
N/A |
MODULATION |
OFDM
BPSK - QAM256 |
OFDM
BPSK - QAM64 |
OFDM
BPSK-QAM64 |
DSSS
DBPSK-CCK |
DATA RATE |
Up to 866 Mbps |
Up to 300Mbps |
Up to 54Mbps |
Up to 11Mbps |
|
80 MHz |
40 MHz |
20 MHz |
40 MHz |
20 MHz |
20 MHz |
20 MHz |
TX POWER |
MCS0: 28 |
MCS0: 28 |
MCS0: 29 |
MCS0/8: 26 |
MCS0/8: 26 |
6 Mbps: 26 |
1 Mbps: 26 |
MCS9: 21 |
MCS9: 22 |
MCS9: 25 |
MCS7/15: 20 |
MCS7/15: 21 |
54 Mbps: 22 |
11 Mbps: 26 |
RX SENSITIVITY (BER=10-6) |
MCS0: -89 |
MCS0: -93 |
MCS0: -94 |
MCS0/8: -88/90 |
MCS0/8: -92/91 |
6 Mbps: -93 |
1 Mbps: -93 |
MCS9: -68 |
MCS9: -71 |
MCS8: -74 |
MCS7/15: -72/69 |
MCS7/15: -74/72 |
54 Mbps: -77 |
11 Mbps: -89 |
OTHER |
Dynamic Channel Selection (DCS) based on interference detection
Dynamic Frequency Selection (DFS) based on radar signature
Automatic Transmit Power Control (ATPC) with EIRP limit support |
Automatic Channel Selection (ACS) |
|
ANTENNA |
|
Radio #1 |
Radio #2 |
XP-10100-SUA |
Two N-type Connectors with built-in Surge Protection |
Two N-type Connectors with built-in Surge Protection |
XP-10150-BS1/SUR |
Integrated 2x2 MIMO 22 dBi Dual Polarized 1 foot Antenna |
Two N-type Connectors with built-in Surge Protection |
|
SECURITY |
|
Radio #1 |
Radio #2 |
ENCRYPTION |
AES 128 |
802.11i/WPA2 and WPA Wireless Security with AES-128, TKIP or WEP |
AUTHENTICATION |
Internal MAC Address Control List, Radius based Authentication |
Enterprise/802.1x, Personal/ PSK (Pre Shared Key) or Open |
802.1X SUPPORT |
|
PEAP, LEAP, EAP-FAST, EAP-SIM, EAP-TTLS, EAP-AKA |
|
QoS |
|
Radio #1 |
Radio #2 |
|
Asymmetric UL/DL committed and maximum information rate per service flow with Best Effort and Real Time Polling Services |
802.11e/WMM Enhanced Distributed Channel Access, 4 priority queues |
Packet Classification Capabilities |
802.1p priority, IPTOS, VLAN ID, IP addresses, ports, Ethernet addresses, IP protocol, and EtherType |
802.1p priority, IPTOS |
|
THROUGHPUT |
|
Radio #1 |
Radio #2 |
Up to 672 Mbps @ 80 MHz |
Up to 150 Mbps |
|
MANAGEMENT |
|
REMOTE |
Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3 |
SNMP |
SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB |
OTHER |
Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer |
SYNCHRONIZATION |
|
Pass-through IEEE 1588v2 Ethernet Synchronization |
NETWORK |
MODES |
Radio #1 |
Radio #2 |
Bridging, Routing (RIP v2 and IP tunneling) |
Access Point |
|
IP STACK |
IPv4 and IPv6 simultaneously |
GATEWAY FEATURES |
DHCP Server & relay, NAT with Std ALGs |
VLAN |
802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging |
POWER |
|
INPUT |
OUTPUT |
36 to 57 VDC via Ethernet port1 (PoE) |
48 to 57 VDC – 25 Watt max on Ethernet port2 (PoE – software controlled) |
12 VDC via Access port |
12 VDC on Access port |
Power should not be provided simultaneously on both ports. |
|
|
POWER CONSUMPTION |
|
|
16.5 Watt typical, 22.5 Watt maximum |
ENVIRONMENTAL SPECS |
|
TEMPERATURE |
OPERATING -40º to 60ºC (-40º to 140º Fahrenheit)
STORAGE -50º to 70ºC (-58º to 158º Fahrenheit) |
HUMIDITY - IP RATING |
100% relative humidity - IP67 |
WIND LOADING |
200 km/h (125 mph) |
PHYSICAL SPECS |
|
|
|
DIMENSIONS |
WEIGHT |
PACKAGED |
XP-10100-SUA |
14.56 x 13.0 x 7.87 in (370 x 331 x 200 mm) |
10.91 lbs (4.95 kg) |
|
XP-10150-BS1/SUR |
14.56 x 13.0 x 7.87 in (370 x 331 x 200 mm) |
11.90 lbs (5.4 kg) |
UNPACKAGED |
XP-10100-SUA |
9.84 x 8.66 x 2.83 in (250 x 220 x 72 mm) |
5.07 lbs (2.3 kg) |
|
XP-10150-BS1/SUR |
12 x 12 x 3.40 in (305 x 305 x 85 mm) |
6.17 lbs (2.8 kg) |
|
SAFETY STANDARDS |
|
|
UL 60950, CAN/CSA-C22.2 No. 60950, IEC 60950, EN 60950 (part -1 and -22) |
CERTIFICATIONS |
|
USA: FCC 90Y + 15C + 15E (UNII 15.247)
Canada: IC RSS 102 + RSS 111 + RSS 247
Europe: RED EN 301 489-1 + EN 301-489-17 + EN 300 328 + EN 301 893 + EN 302 502
Railway: EN 50155 + EN 50121 + EN 61373 |
PACKAGE CONTENTS |
|
|
- One Tsunami® XP-10100-SUA unit with four N-type surge protected connectors
Or One Tsunami® XP-10150-BS1/SUR unit with integrated 22 dBi panel antenna plus two N-type surge protected connectors
- One power injector and country specific power cord
- One Connector weatherproofing kit (Includes all recommended weatherproofing material)
- One Wall / Pole mounting kit
- One Grounding kit
- Two 2.4 GHz, 5 dBi omni antennas
- One Antenna alignment (RJ11) dongle
- One Quick Installation Guide
|
MTBF and WARRANTY |
|
|
>250 000 hours, 2-year warranty; ServPak Extended Support available. |
|